China Fortune Group Co.,Limited
Add: Huandong Street, Zhuji, Zhejiang, China
Contact: Rex Chen
The process of the bottom dead center of the mixing rod of the blending machine (taking the large case as an example)
1, open the needle plate
2, change color to need to adjust the needle bar position
3, the scale to 178 degrees
4, press the needle bar, so that the bottom dead center into the drive block, such as buckle not into the release of the bottom dead screw can be
5, will be dedicated to the bottom of the dead gauge gauge horizontal hanging on the aluminum frame, and buckle into the needle pin chuck
6, loosen the bottom dead screw, press down the needle (to ensure that the needle bar to suppress the lower dead point gauge), and then lock the bottom dead screw
7, confirm the gauge up and down no gap can be removed, turn the dial to 0 degrees, loosen the top dead screw, with the index finger or middle finger down the needle bar, and with a large mother finger to withstand the top dead fast, and then Lock the top dead screw.
Note: 1, transferred to the dead point, should pay attention to the direction of the pin chuck. 2, adjust the bottom dead center, you must adjust the top dead center, but adjust the top deadline, and now more and more popular use of embroidery machine, and a lot of clothing embroidery factory no longer use the traditional embroidery process, all with high-speed blending machine Provide embroidery work efficiency. Blended machine can be used to play version, playing version is what we usually say proofing. Simply put the blender is through some set of procedures to deal with some tricks, we want to play the embroidery pattern, which is the computer embroidery works. The process of proofing is done by a versionator. In fact, the original embroidery machine is the principle of embroidery needle operation, playing the desired embroidery patterns. While the high-speed blending machine is more convenient and fast can play the desired embroidery products.
So how about the cost of blending machine, the requirements of the material is not high? Clothing embroidery factory is no longer the traditional process but the choice of high-speed embroidery machine, which is a certain reason. In fact, embroidery is the most critical is a version of the division, the material is not particularly important, as long as we choose the quality of the material is no problem, then it is not expensive materials to embroidery. We now use the computer to play version, a version of the division can use a monitor or plotter to check the effect of his version. We have to care about is out of the version of the pattern is correct whether there is no problem on the details.
Embroidery by a different needle composition, so we have processed a good fabric, clothing embroidery factory need to be re-processed in accordance with the requirements, continue to use the line for puncture, processing needs of the finished product. In short, high-speed blending machine is very common, the price will not be particularly expensive, the material used is relatively common, as long as the quality of the material is no problem.
China Fortune Group Co.,Limited
Add：Jianglong Zone, Zhuji, Zhejiang, China